Professional manufacture of acrylic bahtub and shower cabin in China.

how to apply acrylic sheet to a shower wall

by:Xavier      2020-04-03
Acrylic wrap provides decoration and simple-to-
Keep the surface of the shower.
Acrylic sheets are made of soft, waterproof plastic and connected to each other in the corner of the shower.
Depending on the current condition of the shower, they can be glued directly to the dry wall or directly to the bolts on the wall.
Acrylic sheets are available in a variety of sizes, configurations and styles.
No matter what type of acrylic surround you are installing or what type of Mount you are using, install the surround the same way.
Lean the first sheet against the back wall of the shower and set a height on the top.
Adjust the paper until it is flat and draw a vertical line on a dry wall or column.
Take the sheets down and repeat them with the two walls around.
While acrylic sheets have many different sizes and styles, they are not pre-drilled for shower valves or shower heads.
To ensure that your cutting of these items is as accurate as possible, create a template for them from the cartons that arrive around you.
Cut the box into the size and shape of the paper mounted on the water wall, then place the paper on the wall, align it with the pencil mark you made, indicating the horizontal line of the paper.
Mark the cardboard where the pipe meets the cardboard.
Cut holes on the cardboard to hold the pipe, then place the cardboard on the top of the acrylic resin and cut the acrylic directly through the holes on the cardboard. Use a glue-
Any acrylic plate mounted on a dry wall, green plate or cement back plate. A glue-
Up installation connect the acrylic resin to the wall panel using adhesive.
Once your surroundings are installed, template and cut, fill the adhesive into the surrounding corner board and press them on the clean and primer wall panels.
Squeeze a line of adhesive below the pencil mark on the wall, indicate the surrounding position, and then at 1-
Surround every 12 inch inches around.
Press the rear panel in place, then slide the two side panels in place and sew a circle into the corner to seal the surroundings.
Consider using direct-to-
Install Bolt acrylic wrap for the surroundings of wall panels without wall panels or in poor condition. In a direct-to-
Bolts are installed, installed, and around the formwork, and any remaining wall panels are then removed to the bolts.
Apply one adhesive directly to the nail and press the sheets in place.
At the top of each sheet used directlyto-
Bolts are installed as flanges;
Screw this flange onto the bolt to secure the surround, then seal the corner and install the new wall panel on the flange for waterproof installation.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...
Dear customer, Due to the large number of inquiries, we may not be able to reply you in time. You can describe what you want, and we will reply you in time.